真人对赌网址

欢迎光临!济南真人对赌网址 供热真人对赌网址 厂,主营: 山东燃气锅炉山东电采暖锅炉山东多介质过滤器和射线防护器材等。
  • 服务热线: 18678809986
  • 真人对赌网址 关于我们 产品中心 真人对赌网址 工程案例 真人对赌网址 选型 联系我们
  • 您的位置: 真人对赌网址 > 真人对赌网址 >

    不锈钢过滤器滤芯维护保养应该注意什么?
    来源:真人对赌网址_99真人备用网址-官网 http://www.loverslame.com 发布时间: 2020-12-23

    1.不锈钢过滤器长期未得以应用时,我们必须要将过滤器内部的滤液排放干净,然后将滤芯拿出,进行洗净烘干流程,当完成这一系列操作后,将产品放入干净的塑料袋内并封口,这是为了保证滤芯产品不被污染.,将不锈钢过滤器擦净存放于干燥处即可.
    1. When the stainless steel filter has not been used for a long time, we must discharge the filtrate inside the filter, and then take out the filter element for cleaning and drying process. After completing this series of operations, put the product into a clean plastic bag and seal it to ensure that the filter element product is not polluted. Finally, clean the stainless steel filter and store it in a dry place
    2.一般,换下来的滤芯要浸泡于酸性强度强的洗液中,浸泡时长约为24小时左右,切记,酸性液体的温度要保持于25-50度左右,在进行浸泡的过程中时,我们建议酸与碱占液体的比例要控制在20%之间,这是为了避免液体对滤芯产品内部的破坏与污染.
    2. Generally, the replaced filter element should be immersed in strong acid detergent for about 24 hours. Remember that the temperature of acid liquid should be kept at about 25-50 degrees. In the process of soaking, we suggest that the ratio of acid and alkali to liquid should be controlled between 20%, which is to avoid the damage and pollution of the liquid to the filter element
    山东多介质过滤器
    3.一般而言,蛋白因子较高的洗液产品好,不管是从清洁度上还是节约上而言,效果都很好.因此,应当利用蛋白含量较高的酶溶液进行清洗.当清理过后,一定要进行二次清洗,并采用蒸汽进行整体消毒,这流程对过滤器的保养更为重要.
    3. Generally speaking, the lotion product with higher protein factor is good, and the effect is very good both in terms of cleanliness and economy. Therefore, the enzyme solution with higher protein content should be used for cleaning. After cleaning, it is necessary to carry out secondary cleaning and use steam for overall disinfection, which is the most important process for the maintenance of the filter
    4.不锈钢过滤器在消毒过程中要注意一定的时间和温度,通常,内部的滤芯产品要在消毒柜中放置130℃/20分钟,消毒温度不宜超过150℃,更长消毒时间不能超过30分钟.要切记,一旦消毒温度过高,抑或时间长、压力大,都会导致过滤器内部元件(滤芯)的整体损坏.
    4. The stainless steel filter should pay attention to a certain time and temperature in the disinfection process. Generally, the internal filter element products should be placed in the disinfection cabinet at 130 ℃ / 20 minutes, the disinfection temperature should not exceed 150 ℃, and the longest disinfection time should not exceed 30 minutes. It should be remembered that once the disinfection temperature is too high, or the time is long, and the pressure is high, the internal components (filter element) of the filter will be damaged as a whole
    真人对赌网址_99真人备用网址-官网 大象彩票app下载安装_大象彩票手机注册平台_大象彩票app下载登录-登录 大象彩票登陆路线入口_大象彩票app入口_大象彩票app最新版下载-登录 大象彩票官网登录_大象彩票手机版_大象彩票app下载-登录 大星彩票福彩体彩_大星彩票苹果版_大星彩票手机版-登录 大信彩票_大信彩票app_信彩彩票app下载-登录 大信彩票官方网站_大信彩票平台_大信彩票注册-登录 大赢家手机投注平台_大赢家体育_大赢家体育官网-登录 大星彩票_大星彩票走势大全_大星彩票尾数走势图-登录 大嬴家体育_大赢家棋牌_大赢家体育比分官网-登录 大赢家斗地主下载_大赢家体育资料库_大赢家即时比分-登录